EDAC Series 570 Waterproof

The EDAC 570 Series waterproof connector has a plastic latch providing both a locking mechanism and polarity. 5.8mm contact spacing. Plug and receptacle in 2 or 3 contact positions. Contact termination options include crimp and PC tail. Tools are available for contact installation, removal and crimping. The 570 Series is able to carry current up to 10A.

There are three groups of connector styles (2 amp, 10 amp, or 15 amp) Crimp contacts can be ordered pre-wired or separately on a carrier strip. From 2 to 9 pins (series 566), 1 to 3 pins (series 570), or single contact only (series 568)

Approved to grade 4 per JIS C 0920-1993 standards; tested to grade 7. Hand tools available for crimping and removing terminals, or use of automated crimp machine.

Typical Applications

LED lighting indoor/outdoor  LED ropes  Rail carriage emergency lighting  Light fittings  Motorway and general traffic signage  Electric mobility vehicles  Electric buggies  Power washers Electronic Tapware

Specifications   Insulator material: PBT (UL94V-0)   Contact material: Brass / Tin plating   Wire housing seal: Silicone Rubber   Current rating: 10 Amperes maximum   Insulator w'stand voltage: 1700 VAC rms at sea level   Insulation resistance: 1000MOhm Min. at 500 VDC   Operating temperature: -40 to +105 Degrees C   Rated voltage: 300 V   Waterproof Grade 4, proven to IP67   For use with PC boards up to (.063") 1.6mm Schematic view   Features
	Completely waterproof approved to IP65. Tested to  IP67
	Secure connection and coding by means of plastic cup
	2 and 3 pole in-line connectors available
	PCB type available in 1, 2 and 3 pole versions
	Crimp or PC tail ~ tools available for crimp contacts
	Maximum current 10A (Series 570)
	Available as pre-made wire or cable assemblies